The Glb.ChargeCode built-in segment attribute is not supported on applications deployed to Windows. It is valid for MCP-based systems only.

Glb.ChargeCode defines the chargecode to be used with the Run and Start logic commands on an MCP-based system. It can be used in Reports to access the chargecode used to run the Report.

Glb.ChargeCode is ignored if the :COD System command is set to 0.

The chargecode that applies to your Report run or WFL job initiation is the chargecode contained in Glb.ChargeCode when the Run or Start logic command is executed.

RIP Reports that are run from WFL have the chargecode set to the name (usercode) station. RIP Reports that are not attached to a terminal have the chargecode set to LINCRIP.

Move the chargecode value into Glb.ChargeCode before the appropriate Run or Start Logic command. Do not include the period on the end of your chargecode, as this is automatically appended.

Refer to the Agile Business Suite Runtime for ClearPath MCP Administration Guide for more information.

Properties

Length = 45

Primitive = String