The Glb.PrintHost built-in segment attribute is not supported on applications deployed to Windows. It is valid only for MCP-based logic.

Glb.PrintHost contains the name of the host computer to which the required destination output device is connected.

Glb.PrintHost is an attribute of outputstreams.

The value of Glb.PrintHost is stored when a Frame is printed. This value is later compared to current values when a PrintFrame command is next used, to determine if a release is required.

The release is not done when the Glb.PrintHost value changes. Such a release is prompted when a difference is detected by a comparison done before a PrintFrame command is executed, not by a Move into Glb.PrintHost.

When output from a Report has been produced, the value of Glb.PrintHost remains until the next Release command (or end-of-job), when the most recent change to its value is then affected.

Glb.PrintHost applies to Reports that use the Report Output Control system, with output directed to Line Printer, Remote Printer, and Terminal Printer devices. By default, the value is the value of Glb.SelfHost.

Properties

Length = 17

Primitive = String