The syntax for this command is as follows:
GENERATEQ [{nn}]Use this command to show or set the Appl Bld monitoring MCP job queue to nn. Appl Bld uses this information to check MCP job queues for any queued system generates.
For system generates, Appl Bld checks the following in order to determine the system generate state:
the job number status (if available)
the MCP job queue defined here
the default MCP job queue for the generate usercode
the default MCP job queue and, finally, all available MCP job queues
If the AB Suite generate WFL has had a CLASS defined then enter this here to minimize any MCP job queue checking.
By default, the queue is 0.
Refer to SCHEDULING command for more information on the generate queue.