Modifying Screen Layouts for a Current Application

This situation applies when your application has been initiated since it was built or configured.

Only existing screen layouts stored in the LINCFORM/LoadED file are required.

However, as FTU requires these to be stored in the LINCFORM file, you must first rename the LINCFORM/LoadED file as the LINCFORM file, by using the command:

 CHANGE system/LINCFORM/LOADED TO system/LINCFORM

The number of sets of screen layouts available to you depend upon the number you have defined in Developer using the Multi Language List. Language positions can be changed or deleted, but the Primary language cannot be deleted.

There is only one version of screen layouts in the LINCFORM file to modify. All screen layouts are thus displayed on page 1 only. The LINCFORM/LoadED file should no longer be present.

Note: Before you can access language copies of ROC screens beyond the Primary language, they must have been added to the LGLOBALFORMS file.