You can specify a device type of EX to send non-Direct ROC output to an Extract file. The Extract file is a standard system data file on disk.
You can specify a device type of EX:
With the Run logic command
With the :RUN Administration command
With the SendPrint logic command
In the Device property of the ROC Write screen
In the Glb.Device built-in attribute in logic
The name of the Extract file is determined as follows:
If the Station name (Glb.Stn) property begins with an asterisk (*), the file name is:
The value in the File name property, if the request is initiated from the ROC Write screen
The value of Glb.Title, in all other cases
If the Station name (Glb.Stn) property does not begin with an asterisk (*), the file name has the following format:
system/ROCEXTRACT/station