Displays or sets the status of the Examiner Library. By default, the setting is :EXM-(disabled). The setting of :EXM is not retained in the database. Security level is Controller.
:EXM displays the status of the Examiner Library. The status is can be either ENABLED (running) or DISABLED (not running).
Refer to the :REL EXM command in :REL EXM Release Examiner, and also Security Features for more information on releasing Examiner files.
:EXM- stops recording, this command disables the Examiner flags for timing points in the Examiner statistics file.
:EXM+ starts recording, this command enables the Examiner flags for timing points in the Examiner statistics file.
The :EXM+ command has the form:
:EXM+ packWhere, pack is a pack for storage of the file of Examiner timing point data.
If a file is already open, it sets flags in COMSTP programs, GLI, Offline, and LSS, to enable Examiner timing points in the application.
If the Examiner Library is not currently running (initialized), a file is opened for recording timing point data. The file has the usercode of the application. If a pack is specified, the file is located on that pack. If no pack is specified, the pack on which the application is configured is used.