The following administration commands relate to the operation of Reports, including utility Reports such as the Report Output Control system (ROC).
Note: Except for :DEL and :REP RECOVER, these administration commands only relate to non-standalone Reports.
Refer to Accept Commands.
| Name | Function |
|---|---|
| :COD | Display/set the chargecode for application-initiated Reports and WFL jobs |
| :DEL | Delete Report recovery information |
| :MXL | Display/set Mix Limit for Reports |
| :REP | Display Status of active Reports |
| :REP REC [key] | Display information about Reports for which there is recovery information stored |
| :ROC | Set number of ROC Reports |
| :RPR | Set Report priority |
| :RUN report | Start a Report (optionally in Recovery mode) |
| :RUN GLI | Start GLI program |
| :RUN OFFLINE | Start OFFLINE program |
| :STR | Stop Report at next Sleep logic command |
| :TER | Terminate a Report |
Refer to Report Operations for more information on report operations. Refer to How to Initiate and Terminate Applications and Reports for more information on report initiation and chargecodes.