Note: Pressing the physical reset button on the InfiniBand-Ethernet gateway switch reboots the switch but does not reset it to factory default configuration.
If you need to reset the InfiniBand-Ethernet gateway switch to the default configuration from the factory, execute the following CLI command:
reset factory keep-basic
The command resets the switch while maintaining the gateway license and management port IP addresses that were configured at the factory.
After the reset, execute the following CLI commands to set the switch into gateway mode:
system profile vpi-single-switch no ip routing ip proxy-arp
Note that after a reset to the factory default configuration, ports 1 through 10 are once again configured as Ethernet ports, and ports 11 and 12 are once again configured as InfiniBand ports. If desired, change the configuration; see Configuring InfiniBand-Ethernet Gateway Switch Port Type for more information.