To verify or set up the InfiniBand-Ethernet gateway switch for health monitoring by the Fabric Manager, do the following:
Access the web management interface for the switch. For more information, see Accessing InfiniBand-Ethernet Gateway Switch.
On the Setup tab of the management console, in the left-hand navigation, click SNMP.
The SNMP configuration page appears.
Under the SNMP v3 Users section, locate the user admin, and then click Edit.
The Edit SNMP v3 User page appears.
Ensure the Enable user checkbox is selected.
Verify or set the authentication password to authauth.
Verify or set the privacy password to passpass.
Click Apply, and then click OK.
Click Save in the upper right area of the management console to save all changes.
The InfiniBand-Ethernet gateway switch is now ready for health monitoring by the Fabric Manager.
If necessary, use the Fabric Manager user interface to add the InfiniBand-Ethernet gateway switch to the fabric. For more information, see the help associated with the Fabric Manager or Adding a Switch.