Inquiring on the Routing Information Protocol (RIP)

Note: This feature is supported only in the IPv4 operating mode.

You can inquire on the current Routing Information Protocol (RIP) status and obtain configuration information for your system using the TCPIP RIP inquiry.

Issue the inquiry as follows:

NW TCPIP RIP

Response Examples

RIP is enabled on the system with two active devices. Each device is listening to the RIPv2 multicast address. 

Rip is enabled.
NP 254 Line 1 supports RIP Version 2
NP 255 Line 2 supports RIP Version 2

RIP is enabled on the system with three active devices. Two of the devices are listening to the RIPv2 multicast address. 

Rip is enabled.
NP 253 Line 1 supports RIP Version 2
NP 254 Line 1 supports RIP Version 2
NP 255 Line 1 supports RIP Version 1
Prev  Up  Next
Specifying Selection Criteria for Route Inquiries  Home  Setting the Routing Information Protocol Authentication Type