LOGANALYZER can be initiated from a CANDE or MARC session, an ODT, or a WFL program. The following table shows the commands or selections available for initiated LOGANALYZER from each of these sources:
|
Source |
Input |
|---|---|
|
CANDE, ODT, WFL |
LOG <option list> command |
|
CANDE, MARC, ODT, WFL |
RUN *SYSTEM/LOGANALYZER ("<option list>") command |
|
MARC |
LOG selection on LOG menu |
| Note: | When the RUN command is used, the entire <option list> must be enclosed in quotation marks. For individual options that include string values, these string values must be enclosed in double sets of quotation marks. |
If LOGANALYZER is to be run on an operator display terminal (ODT) configured to be in data comm mode, it should be run through Menu-Assisted Resource Control (MARC).
If LOGANALYZER analyzes at least one entry, it sets SW1 to true.
Once LOGANALYZER is running, the user can find out how much of the log has been analyzed at a given moment by entering ?HI on a CANDE terminal or <mix number>HI on an ODT. The following is an example of the display that is returned when ?HI or ?2660HI (through CANDE) is entered:
#2660 DISPLAY: LOG 60% READ.
When the LOG option is selected from MARC, a series of screens is presented that allow the user to select options for a LOGANALYZER report.
