The SFV command displays either a specific system file, or the entire System File Vector. If the entire System File Vector is displayed, then additional information (such as the in-use count) is also shown. The FIB associated with each file is analyzed.

Syntax

── SFV ─┬──────────┬───────────────────────────────────────────────────┤
        └─<number>─┘

Explanation

The following text describes the usage of the SFV command.

SFV

The entire System File Vector is displayed.

SFV <number>

If <number> is within the valid range, then the system file at offset <number> in the System File Vector is displayed. If the entry specified by <number> is not in use, then the response “Available” is displayed.